TheGunMag – The Official Gun Magazine of the Second Amendment Foundation
  • Home
  • ABOUT US
    • COLUMNISTS

Weingarten’s Reichsrevolver Redux Brings Historic Wheelgun up to Snuff

Posted By GunMagStaff On Thursday, November 19, 2026 05:05 AM. Under Featured  
Weingarten with dot sighted Reichsrevolver. He considers it his “Star Wars” revolver.  Shoot from a supported position when you can. 

By Dean Weingarten | Contributing Writer

   In a previous article, I wrote about the 1883 Reichsrevolver this correspondent possesses.

   It was manufactured in 1893. I did some gun plumbing and made the revolver serviceable with some homemade, nonstandard parts. 

   At 10 meters, the six shot group from the 1883 is 2.5 inches high and 2 inches left. It appears Reichsrevolvers were regulated to shoot 350 mm (14 inches) high at 25 meters. The Reichsrevolvers shot by this correspondent confirm this. The sights are rugged and fixed. Translated from this source: 

    “For practice, the soldier shot at a disc 25 meters away, the stopping point of which was 350 mm below the center of the disc ( 70 ). The Reichsrevolver therefore wanted about 350 mm of a large shot at a distance of 25 m in the case of a fixed sight in order to bring hits to the man in the battle distances for the revolver shot.”

1883 Reichsrevolver, shown with a group shot at 10 yards using .44 Russian Ultramax ammunition. 

   This 1883 model Reichsrevolver has good mechanical accuracy. Unfortunately, the sights are not close to point of aim for field work. For an old target shooter, this is not acceptable. 

   Possible corrections were considered. The revolver is already non-standard. Adding some material to the front site was a possibility. Making a front sight which could be clipped on and removed was considered. Mounting a dot sight was a third option.

The top strap of the Reichsrevolvers is very close to the relevant dimensions on a weaver rail. It is a little short of 21 mm at the widest. 

   I did not want to drill holes or remove material from the revolver frame. The top strap of the Reichsrevolver frame was measured. It was surprisingly close to the width and bevels of a weaver rail, and the top of the top strap is flat. 

   Over decades, this correspondent has collected a number of odds and ends. Looking in a mounts and optics box, an adapter to convert a Weaver/Picatinny rail to a Red Dot SMS platform was found.   

Left side of the Kel Tex/Veridian dot sight mounted on the Optima/JPoint adaptor. Note the clamp butted against the front of the frame opening.

   It worked! Who would think a revolver’s dimensions, designed in 1878-79, would work to fit a dot sight mounting system? These mounts are still available on the Internet. They are not expensive. There are some available from CDNN. If you have a Reichsrevolver, and want to be able to shoot to point of aim, you might consider one. 

   The adapter worked well. Iron sights can be precise, with good lighting and good eyes. Dot sights make precise shooting much easier. The revolver shot a 1.33-inch group at 10 yards with iron sights from a rest, as shown. The target shot at 10 yards with the dot sight and a rest was a little better, at 1.06 inches. The advantage of the dot sight is it can be adjusted to shoot to point of aim. It is much easier for old eyes to use. 

   Adjustments were made using the dot sight. It appeared to take recoil well. Remember to butt the clamps on the mount to the front of the inside revolver frame. 

Groups shot at 10 yards with Ultramax 200 grain factory ammunition were a little more than 1 inch. 

The less than 2.5 inch group at 25 yards was the result. 2.5 inches at 25 yards is what is expected from a stock Glock pistol. 240 grain 10x25R/.44 Russian reloads are expected to shoot an inch higher.  

The groups shown were shot with Ultramax 200 grain .44 Russian ammunition. Velocity averaged 771 fps. 

The revolver was shot at 25 yards from a Caldwell Pistolero Rest. Velocities were measured with a Garmin Zero C1 Pro.  

There are superb modern revolvers which can be obtained for less, which shoot just as well, have excellent parts support, and much greater ammunition availability.  Why go to the trouble and expense of making an old revolver into a reliable shooter? 

The iron sights are not usable as backup sights with the dot sight installed. The rear sight and the front sight are both too low. 

It is fun. It is enjoyable in its own right. 

There are several jurisdictions where possession of a revolver which is legally an antique is much easier than possession of a modern firearm. Canada is one such jurisdiction. The Reichsrevolvers are known as very tough, very reliable revolvers.

 There were about 250,000 to 500,000 of these revolvers made from 1879 to 1894. Some records were destroyed during WWII. There are much better handguns available for duty or combat.

   The Reichsrevolvers were designed to use a separate ejector rod. It is not a difficult thing to make or improvise. For uses which are not police duty or military, the Reichrevolvers can perform well. A Reichsrevolver which works is far better than not having a firearm. 

   For field use, the revolvers are reasonably precise. The original sights require annoying windage and elevation correction. Correcting for more than 3 inches at 10 yards is annoying. It takes time. The dot sight corrects this and makes small game harvest or defense against large animals reasonable to 25 yards. It is a single action design. This 1883 model revolver has a trigger pull of about six ponds. It is a little heavy, but usable. 

   Reichsrevolvers were made with good German steel from the beginning. It was an improvement over the malleable iron used in the early Colt SAA revolvers. The cylinder has a larger diameter than the Colt. The Reichsrevolver is about  1.75 inches in diameter vs 1.65 inches for the Colt. A tenth of an inch is significant. 

Except for the National Match Slow fire target, all groups were shot with Ultramax 200GR Round Nose FP ammunition. Velocity was measured with a Garmin Zero C1 Pro. The average was 771 fps for the 200 grain load. 

   The chambers are for 10.6x25R/44 Russian, which was being made in Germany at the time the revolver was designed and manufactured. A larger diameter cylinder and smaller than .45 Colt chambers suggests the cylinder is considerably stronger than the contemporary .45 Colt cylinder. The solid frame is stronger than the S&W top break Russian #3, contemporary of the Reichsrevolvers, also chambered for the .44 Russian.  

   These are old revolvers. The one seen in these images is over 130 years old. Be careful. Don’t expect more of them than they can deliver. Make sure the revolver is in good condition before attempting to shoot them..

    There are advantages to shooting smokeless loads loaded to pressures less than the original black powder loads. There is less corrosion. Cleaning is a bit easier. 

   Smokeless powder has the potential to deliver the same energy with a little less pressure than a similar load with black powder. This is because smokeless powder delivers much greater energy per grain or gram, about two to three times as much. This means you are accelerating less weight of powder with a shot, with smokeless powder. This compensates a little for the danger of smokeless powder. It is much easier overload with smokeless powder for the same reason. You can fit two to three times as much powder in the same space. A double load is very likely to wreck an old revolver, because of the extreme increase in pressure. Smokeless loads for the .44 Russian are about one-fifth the weight of black power loads. Use quality loading manuals.

   This correspondent thinks the Reichsrevolvers are the current “best buy” if you want to have a “real” handgun in Canada. Some people in the USA can also benefit. The local laws are numerous and variable. Find out what they are. You do not want to be caught up in the legal system. 

← ATF: Pastor Russell Fincher’s Guns Were All Destroyed Before His Presidential Pardon
Blistering Battle of Words Erupts over NY Times’ 2A ‘Misquote’ Article →
  • Useful Gun Owner Links
    • Armed American Radio
    • Citizens Committee for the Right to Keep and Bear Arms (CCRKBA)
    • Doctors for Responsible Gun Ownership (DRGO)
    • International Association for the Protection of Civilian Arms Rights (IAPCAR)
    • Jews for the Preservation of Firearms Ownership
    • Keep And Bear Arms (KABA)
    • Polite Society Podcast
    • Second Amendment Foundation (SAF)
    • Tom Gresham's Gun Talk
    • US Concealed Carry Association
  • ADVERTISEMENT
  • ARCHIVES
  • ABOUT US
Copyright © 2026. All Rights Reserved.